Configuring the Format of the RADIUS Password Attribute when Authenticating NEAP MAC Addresses using RADIUS
Use the following procedure to configure the format of the RADIUS password when authenticating NEAP MAC addresses using RADIUS.
Procedure
Variable Definitions
The following table defines parameters for the eapol multihost non-eap-pwd-fmt command.
Variable |
Value |
---|---|
ip-addr |
Management ip-address of the switch. |
key WORD<1-32> |
Key value used for non-eap password format. |
mac-addr |
Mac-Address of the client. |
padding |
Includes a dot in the RADIUS password for every missing parameter. |
port-number |
Index of the port on which MAC is received. |
Note
To derive the port number for an interface, use the command show interfaces gigabitethernet {sub-port]][,...][slot/all][all]} .
If you configure interface 1/6 on the product, to derive the port-number for this interface, use the command show interfaces gigabitEthernet 1/6. From this command, you can ascertain that port number used in the NEAP password is 197.
Switch:1(config)# show interfaces gigabitEthernet 1/6 ========================================================================================== Port Interface ========================================================================================== PORT LINK PORT PHYSICAL STATUS NUM INDEX DESCRIPTION TRAP LOCK MTU ADDRESS ADMIN OPERATE ------------------------------------------------------------------------------------------ 1/6 197 1000BaseTX true false 1950 f8:15:47:e1:dd:05 up up